Hoshizaki KM-1601SWH/3 - Manual (Page 17)

17
6) Install the bin control thermostat as follows:
a. Remove the baffle from the storage bin.
b. Remove the tie securing the bin control thermostat assembly. Remove the
2 thumbscrews below the bin control thermostat assembly.
c. Remove the bin control thermostat assembly from the shipping hook by lifting it up
and shifting it to the right. Lower the thermostat extension bracket (stainless) with
the thermostat bulb attachment and thermostat bulb through the hole located at
the bottom of the icemaker. Next, lower the thermostat bracket (plastic) through the
hole. See Fig. 3.
d. Make sure the left side and bottom of the assembly are flush against the wall and
base panel.
e. Secure the assembly into place with the thumbscrews (unless you are installing
an upper unit). (See "II.E. Installation of Upper Unit.")
f. Insert the plug into the receptacle on the assembly until it locks into place. See Fig. 4.
Shipping Hook
Bin Control Thermostat Assembly
Thermostat Bracket (plastic)
Tie
Thermostat Bulb
Attachment (plastic)
and Thermostat Bulb
Thumbscrew
Thermostat Extension
Bracket (stainless)
Hole
Wall
Fig. 3
Plug
Receptacle
Thumbscrews
Hook
Bushing
Fig. 4