Hoover WindTunnel Upright Bag Vacuum Cleaner - Manual (Page 5)

2. How to use
Cleaner description
15.Furniture guard: helps
prevent cleaner from mark
ing furniture.
16.Nozzle control knob: slide
knob to correct setting for
height of carpet being
cleaned.
17.Headlight
18.Embedded Dirt FIND-
ERTM
sensitivity switch
19.‘Dirt FINDER’ display
20. Check bag indicator
21.Stair cleaning handle:
located below lower edge
of door.
22. Bag door
23. Cord clip
24. Hose rack
Operate cleaner only at volt-
age specified on data plate
on bottom of cleaner.
This cleaner is intended fo r
The assembled cleaner will
look like the drawing.
1. Handle
2. ON/OFF switch
3. Cord hooks: wrap cord
around hooks for storage.
The top hook can be
rotated right or left for
easy cord release.
4. Hose
5. Tool cover
6.
Dusting brush
7. Furniture nozzle
8. Crevice tool
9. Powered hand tool
10. Carrying handle
11.Wands
12. Final filter door
13. Handle release lever:
step on lever to lower
handle to operating or
low positions.
14. Edge groomers
5
2 - 2
ON-OFF switch
Plug cord into electrical outlet.
To turn cleaner ON, push switch up.
To turn cleaner OFF, push switch down.
1
2
3
4
3
3
5
6
7
8
9
10
11
12
13
13
14 14
15
16
17
18
19
20
21
22
23 24
STEP III Position tools
household use.
Polarized plug
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
Cord clip
To help keep the cord out of the way
while vacuuming, position cord in cord
clip (A) located at rear of cleaner on
hose rack.
1-15 1-16
1-14
Place smaller unridged end of wand into
bottom of rack. Snap wand into clip.
Repeat with other wand.
Open tool cover.
Insert ends of dusting brush (A), crevice
tool (B) into storage areas. Secure furni-
ture nozzle (C) in clip.
Close tool cover. Remove switch lock (A) above ON/ OFF
switch (B) by pulling it straight out.
Dispose of switch lock.
If switch lock has come off during
assembly, make sure switch is in OFF
position (down) before plugging cord
into electrical outlet.
A
2 - 1
A
A
C
B
B