beautypg.com

Quick cord release, Air freshener dispenser, Cleaning tools – Hoover R3 7-96 User Manual

Page 7

background image

11

12

4

Use tools with cleaner handle
in upright position.

HOSE CON-
NECTOR

HOSE
DOOR

performance.

With cleaner handle in upright
position, open hose door and
insert hose connector until it
snaps into position. Suction
will automatically be diverted to
the hose when cleaner is
turned on.

Note: Hose must be removed
from hose door when clean-
ing carpet and floors to
insure proper cleaning

Quick cord release

To release the cord, rotate top
cord hook. The hook can then
be repositioned for wrapping
the cord.

MIN

MAX

The amount of fragrance
released is regulated by sliding
the control to the left and right.

Air freshener tablets may be
obtained from your local Autho-
rized Hoover Dealer (Depot), a
Hoover Factory Service Center,
or by using the mail order form
packed with your cleaner.

To remove hose, press latch on
hose connector and pull up.

To replace drawer, insert
bottom part of drawer in slot on
bag door. Push drawer into
position.

Slide drawer on front of bag
door all the way to the right.
Insert a finger in the recessed
area and pull drawer foward.
Insert the air freshener tablet
packed with cleaner.

Air freshener
dispenser

(Some models only)

Cleaning tools

The cleaning tool set includes a
hose, dusting brush, furniture
nozzle, crevice tool, and an
extension wand, bare floor tool
*(some models only)

Turn cleaner OFF before
attaching or removing hose.

A. Attach hose to
cleaner

1

2

3

B. Select proper tool

1. Dusting brush

may be used

for carved furniture, table tops,
books, lamps, lighting fixtures,
venetian blinds, baseboards,
shutters, and registers.

2. Furniture nozzle

may be

used for upholstered furniture,
draperies, tapestries, mat-
tresses, clothing, automobile
interiors, and carpeted stairs.

3. Crevice tool

may be used in

tight spaces, corners and along
edges in such places as dresser
drawers, upholstered furniture,
stairs, and baseboards.

4. Wand

is used to give extra

length to your hose. Attach it to
any of the above tools.

*5. Bare floor tool

may be used

for very irregular hard surface
floors such as brick and slate.
*Included with some models.

*

*5