Hoover R3 7-96 - Manual (Page 4)

5 6
CAUTION: When cleaner is turned on, agitator will continue to
rotate while cleaner handle is in upright position. Avoid tipping
cleaner or setting it on furniture, fringed area rugs, or carpeted
stairs during tool use. Avoid leaving the cleaner in one place for
an extended period of time particularly on thick carpet.
Note: If switch lock has come
off during shipping, make sure
switch is in the OFF position
(down) before plugging cord
into an electrical outlet.
Dispose of switch lock.
Pull switch lock, above ON/OFF
switch, straight out.
SWITCH
LOCK
ON/OFF
SWITCH
2. Attach tools
Pull open tool cover.
➘
HOSE
CONNECTOR Note: Hose must be removed
from hose door when clean-
ing carpet and floors to insure
proper cleaning performance. ➘
Questions or Concerns?
The Hoover Company wants to quickly resolve any concerns about
your cleaner or questions regarding its use. Look on the list pro-
vided with the product for your local
Hoover Factory Service
Center or in the Yellow Pages under “Vacuum Cleaners - House-
hold” for the nearest Authorized Hoover Warranty Service Dealer
(Depot) or call:
1-800-944-9200 for an automated referral of authorized
service outlet locations (U.S. only)
OR
330-499-9499 to speak with a representative in the
Hoover Consumer Response Center.
DO NOT RETURN THIS PRODUCT TO THE STORE OR SEND IT
TO NORTH CANTON FOR SERVICE.
How to attach
hose and tools
1. Attach hose
With cleaner handle in upright
position, push round end of
hose
firmly into “cup” in rack.
Stretch hose over rack and
push hose connector into rack
until latch snaps into place.
Position wand, with smaller end
down, in side of holder and snap
into place.
A
B
C
Snap furniture nozzle (A),
dusting brush (B), and crevice
tool (C) into tool storage area as
shown.
Close tool cover.
To remove hose, depress latch
and pull up.
LATCH
➘