Hoover FloorMAX Supreme - Manual (Page 4)

4
Remove tank from shampoo-polisher and
remove nut, bolt and cord clip from top
of lower handle section.
1-3 1-4
Join upper and lower handles, lining up
holes. Place cord clip around cord with
flat side toward handle and holes to
front.
2. How to use
ON-OFF switch
The floor machine’s ON-OFF switch is
internal and is operated by lowering
and raising the handle. Be sure han-
dle is in lock (upright) position before
connecting power cord to wall outlet.
Start floor machine by pressing handle
release lever and lowering handle. Raise
handle to lock position to stop floor
machine.
2-1 2-2
To attach brushes
Press each brush down firmly over
brush shaft (A), rotating brush until it
clicks into position. To remove—grasp
center of brush with thumb and fingers
and lift up.
To attach pads
Insert end of fastener through opening in
pad. Place pad over
power scrub and
cleaning brushes only.
The fastener fits around the brush shaft.
Press the fastener to snap into place.
Unsnap fastener to remove pad.
2-3
Attaching tank
Attach brushes and pads before attach-
ing tank.
Set bottom of tank into tank support.
2-4
Turn tank cap lock until the rivet is
directly above slot. Raise tank cap lock
and tank cap. Snap tank against handle.
2-5
Push tank cap down. Slide cap lock
down and turn right or left to lock tank
and cap into position.
Connect handle
Polarized plug
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.
Insert bolt through cord clip and
through small holes of handle; secure
with nut. Pull up slack in cord and tight-
en nut with screwdriver.
Attaching and removing brushes and pads
Disconnect from electric circuit before putting on or removing brushes.
Place shampoo-polisher upside down on flat surface.
A