Before you for – Hotpoint HDA2030 User Manual

Page 9

This can be caused by

either of

these reasons:

Not enough water is entering the

the door. If there is no water in the bottom of the

dishwasher.

dishwasher, check the

supply to the dishwasher.

●

Is the

dishwasher water supply

on?

usually located under the sink.)

. Is the household

supply turned on?

If you use well or cistern water, is the supply

If the water supply is

try the cycle again. If

repeats,

for service.

The drain pump could be

the door. If there is standing water in the bottom of

temporarily blocked (usually

the dishwasher,

the door, touch

then

caused by food particles such

immediately touch

to start the pump.

as cereal).

continues to appear, you may need do this

times to breakup the blockage.

The temperature sensor in the

The temperature sensor

to be replaced.

for

dishwasher is not functioning

service.

properly. Dishwasher may
continue to be used, but it will

You may continue to use your dishwasher. For best results

not heat water automatically.

adjust your household water heater thermostat to

Before you

for

●

Try the cycle again to see if

Code

reappears. The dishwasher

may correct itself.

●

Electronic controls can be

affected by outside interference.

Sometimes shutting off the power

to the dishwasher (at the fuse or
circuit breaker) will correct the
problem.

. Restore power after about five
seconds and try the cycle again.

. Check the guide above for things

you can do to correct the problem.