Hotpoint HDA2030 - Manual (Page 8)

The DISPLAY tells you if certain things are wrong
IT TO DO
Electrical power has been
r
IF DISHWASHER WAS IN USE WHEN THE POWER
interrupted to the dishwasher but is FAILURE OCCURRED:
now back on.
1. Unlatch the door. If the detergent cup is open, add
detergent and close the cup.
2. the door and touch “START” then immediately
touch (This will pump any remaining
water out of the machine. )
3. Select the desired cycle and rerun the load.
IF DISHWASHER WAS IN USE:
1. Latch door.
2. Select desired cycle.
3. Run cycle when desired.
The dishwasher is taking longer This dishwasher is designed to automatically compensate
than normal to drain the water out. for longer than normal drain times, but cycle time will be
This is usually caused by a blockage extended. If this code continues to appear frequently then:
in the drain air gap (see page 19), a 1. Clean the air gap (see page 19).
drain or a stopped for a in the drain hose.
up drain pipe.
3. Check plumbing for slow or stopped up drains.
Warranty service does not cover household
drain problems.)
Similar to blocked drain as Locate and remove the blockage in the drain system as
explained above, but the explained above. To pump any remaining water out of the
indicates that the drain is so machine:
clogged that the dishwasher cannot
1. Latch door.
continue to operate in a satisfactory
manner. Dishwasher will stop.
2. Select any cycle.
3. Touch “START” and then immediately touch “CLEAR/
Warranty service does not cover
household drain problems.)
3 Dishwasher will not go into a drain Restart the cycle. If repeats, call for service.
out period. Dishwasher will stop.
There is too much water in the The dishwasher is designed to automatically pump out extra
dishwasher. If appears after a water as long as the door is latched. When you hear the
power failure, this is normal and motor stop running:
the dishwasher will correct itself.
1. Unlatch the door and see the water is gone. (It is
normal for a small amount of water to remain in the
bottom of tub to keep the water
lubricated.)
2. If you see water entering the dishwasher, close and latch
the door. Shut off the water supply to the dishwasher.
If water is gone and no water is entering the dishwasher,
restart cycle.
4. If shut off the water supply to the dishwasher.
Call for service.
8