Harman-Kardon 60BQ - Manual (Page 9)

9
+ –
+ – + –
+ – + –
PL0004-01001
LEFT
LINE-LEVEL
OUTPUTS
L R
+ – + –
+ –
+ –
+ –
+ –
+ –
RIGHT
SURROUND FRONT CENTER
Front Left Front Right
Surround
Left
Surround
Right
Center
Subwoofer
Receiver
RCA Cable
(Not Supplied)
(Red and White Ends)
Surround Left
Speaker Cable
(Blue Bands)
Front Left
Speaker Cable
(White Bands)
Front Right
Speaker Cable
(Red Bands)
Center
Speaker Cable
(Green Bands)
Surround Right
Speaker Cable
(Gray Bands)
Connecting the Subwoofer to a Receiver
or Preamp/Processor With Line Outputs
Use this installation method for receivers and preamp/processors that do not have
a dedicated subwoofer output but do have preamp-level (volume-controlled) line
outputs. If the receiver or preamp/processor has a dedicated subwoofer output
with low-pass filtering, see Connecting the Subwoofer to a Receiver or Preamp/
Processor With a Dedicated Subwoofer Output, on page 8.
If you’re connecting to a receiver with left and right line outputs that are not
connected to amplifier inputs, connect the LFE (purple) connector of the supplied
combination LFE and trigger cable to one of those outputs and to either of the
HKTS200SUB’s Line-Level L/R In Connectors 6. Use a second RCA cable (not
supplied) to connect the other receiver or preamp line output to the other of the
HKTS200SUB’s Line-Level L/R In Connectors 6.
If you’re connecting to a receiver or preamp/processor with left and right line
outputs that are connected to amplifier front left and front right inputs, connect
the single line outputs. Connect one of the Y-adapter’s double ends to the
HKTS200SUB’s Line-Level L/R In Connectors 6, and connect the other
double end to your amplifier’s front left and right inputs.
Connect each satellite speaker and the center speaker to the correspond-
ing speaker terminals on your receiver or amplifier.
Configure your receiver or preamp/processor’s setup menu for Subwoofer
ON, and set the front left, front right, center and surround speakers to Small.
After you have made and verified all connections, plug the HKTS200SUB’s
AC Power Cord 8 into an active AC outlet.
Setup Instructions
HKTS 60BQ