Harman-Kardon AVR 510 - Manual (Page 2)

2 TABLE OF CONTENTS
3 Introduction
4 Safety Information
4 Unpacking
5 Front Panel Controls
7 Front Panel Information Display
9 Rear Panel Connections
11 Main Remote Control Functions
14 Zone II Remote Control Functions
15 Installation and Connections
18 System Configuration
20 Input Setup
20 Surround Setup
21 Delay Settings
22 Speaker Setup
23 Output Level Adjustment
23 Crossover Frequency
24 Manual Output Level Adjustment
26 Operation
26 Basic Operation
26 Source Selection
27 Surround Mode Chart
28 Surround Mode Selection
28 Digital Audio Playback
28 Selecting a Digital Source
30 Tuner Operation
31 Tape Recording
31 Front Panel Input/Output
Connections
31 Output Level Trim Adjustment
32 6-Channel Direct Input
33 Advanced Features
33 Display Brightness
33 Turn-On Volume Level
33 Semi-OSD Settings
35 Multiroom Operation
36 Programming the Remote
36 Direct Code Entry
36 Auto Search Method
36 Code Readout
37 Learning Codes
37 Erasing Learned Codes
37 Macro Programming
38 Programmed Device Functions
39 Volume Punch-Through
39 Channel Control Punch-Through
40 Reassigning Device Control
Selectors
41 Function List
43 Setup Code Tables
53 Troubleshooting Guide
53 Processor Reset
54 Notes
55 Technical Specifications
AVR 510 Audio/Video Receiver
Typographical Conventions
In order to help you use this manual with the remote control, front panel controls and rear panel
connections, certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front panel button, or rear panel
connection jack
EXAMPLE – (OCR type) indicates a message that is visible on the front panel information display
EXAMPLE – (outlined type) indicates a lit indicator in the front panel information display
1 – (number in a square) indicates a specific front panel control
¡ – (number in a circle) indicates a rear panel connection
a – (number in an oval) indicates a button or indicator on the remote
A – (letter in a square) indicates an indicator in the front panel display
å – (letter in an oval) indicates a button on the Zone II remote