Error message & possible solution – Hanns.G HU171D User Manual
Page 21
User’s Manual
ERROR MESSAGE & POSSIBLE SOLUTION
CABLE NOT CONNECTED :
1. Check that the signal-cable is properly connected, If the connector is loose, tighten
the connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode, set the computer to display
mode given in the following table.
FACTORY PRESET TIMING TABLE:
VIDEO MODE
RESOLUTION
HORIZONTAL
FREQUENCY (kHz)
VERTICAL
FREQUENCY (Hz)
640 Ч 480
31.469
59.94
640 Ч 480
37.500
75.00
VGA
640 Ч 480
37.861
72.81
800 Ч 600
35.156
56.25
800 Ч 600
37.879
60.32
800 Ч 600
48.077
72.19
SVGA
800 Ч 600
46.875
75.00
1024 Ч 768
48.363
60.00
1024 Ч 768
56.476
70.07
XGA
1024 Ч 768
60.023
75.03
1280 Ч 1024
63.981
60.02
VESA
SXGA
1280 Ч 1024
79.976
75.03
640 Ч 350
31.469
70.09
640 Ч 400
31.469
70.09
IBM DOS
720 Ч 400
31.469
70.09
640 Ч 480
35.000
66.67
832 Ч 624
49.725
74.55
MAC
1152 Ч 870
68.681
75.06
21
- HH221HPB (2 pages)
- HP191 (25 pages)
- HP191 (24 pages)
- HG281DJ (1 page)
- JW199D (18 pages)
- Hi221DPB (15 pages)
- HW191AP (1 page)
- HH-181APB (1 page)
- HG221A (20 pages)
- HQ191DP (1 page)
- HSG1034 (21 pages)
- HG216 (22 pages)
- HG216DP (1 page)
- JW197D (22 pages)
- HW Series (18 pages)
- HH191 (22 pages)
- HH191 (18 pages)
- HW194DJ (2 pages)
- HU171DP (1 page)
- HW-216DPB (1 page)
- HG-216DPB (1 page)
- HQ-191DPB (1 page)
- HC19 Series (20 pages)
- HL221 (22 pages)
- HX-191DPB (1 page)
- HW-191DPB (1 page)
- HG171AB (1 page)
- HB-191DPB (1 page)
- HB171AB (1 page)
- HG191 (17 pages)
- HG191 (20 pages)
- JC199 (20 pages)
- JC199 (14 pages)
- HH251 (17 pages)
- HH251 (21 pages)
- HH221 (23 pages)
- HG-171DPB (1 page)
- HW223DPB (16 pages)
- HSG 1070 (22 pages)
- HG221AP (1 page)
- HW193DP (1 page)
- HSG1040 (22 pages)
- HH181AP (1 page)
- HW173AB (1 page)
- HQ171DP (2 pages)