Hampton Direct H25-NG1 - Manual (Page 21)

Hampton ® H25-1 Direct Vent Freestanding Gas Stove 21
Pipe Length (max. 18")
Part (6-5/8" Dia)
(4" Dia.)
Decorative
Wall Trim
Part #640-545/P
Horizontal
Terminal
Part# 640-530/P
Wall Thimble
Part # 946-202
(required for
combustible walls)
Vinyl Siding
Standoff (Optional)
Part #946-205
Adapter
Part #946-219/P
(required)
INSTALLATION
RESIDENTIAL AND MANUFACTURED HOMES / MOBILE HOMES
MINIMUM HORIZONTAL TERMINATION INSTALLATIONS
You will require the following components with your new Hampton ® Rear Vent Direct Vent Free-
standing Gas Stove. Please review your product to make sure you have everything you need. In
the event that you are missing any part, contact your dealer. Decorative brass
or chrome trim kits are available from Simpson Dura-Vent for their
wall thimbles, as well as a square wall thimble cover.
Planning Your venting Installation
See the "Exterior Vent Terminatal Locations"
section for requirements. The H25 is approved
for a minimum horizontal termination with the
FPI Riser Vent Kit. See the diagram for minimum
and maximum pipe lengths.
When planning your installation, it will be nec-
essary to select the proper length of vent pipe
for your particular requirements. Determine the
minimum clearance to combustibles from the
rear of the unit to the wall. It is also important to
note the wall thickness. Before cutting the vent
hole through the wall ensure that ALL vent and
termination clearances (see the "Exterior Vent
Terminal locations" section) will be met.
*If this is an outside corner, the minimum distance
between the vent and the outside corner is 6"
(15cm). See "F" on the diagram in the "Exterior
Vent Terminal Locations" section.
NOTE: Ensure compliance with the outside
vent terminal location before cutting hole as
both dimensions must be met.
Note: These are the minimum pieces re-
quired. Other parts may be required
for your particular installation.
Minimum components for a Horizontal Installation:
640-944
Horizontal Termination Kit which includes:
1 6-5/8" Dia. x 18" Black Pipe
1 4" Dia. x 18" Aluminum Vent
1 946-202 Wall Penetration Heat Shield (Wall Thimble) (2 pcs)
1 640-530/P Riser Vent Terminal
1 640-545/P Decorative Wall Trim (Black)
1 948-128 Tube Mill-Pac
Screws
946-219/P 1 Adapter
Optional Components:
946-204
45 o Elbow - 6-5/8" Black pipe
and 4" Aluminum Vent
946-205 Vinyl Siding Shield for Riser Vent
Terminal
946-208/P Vent Guard
940 Square Wall Thimble Cover*
981 Snorkel Termination (36")*
982 Snorkel Termination (14")*
942 Wall Penetration
Heat Shield*
* Simpson Dura-Vent components