beautypg.com

Hitachi CM650ET User Manual

Page 6

background image

n NEVER REMOVE THE REAR COVER !

__ The rear cover MUST be removed only by authorised service personnel. This

monitor contains high voltage components.

n THE POWER POINT SHOULD BE CLOSE TO THE MONITOR AND

EASILY ACCESSIBLE !

n INSTALL THE UNIT IN AN SUITABLE ENVIRONMENT !

DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.

This unit is designed to be used in an office or business environment.

DO NOT subject

the unit to vibrations, dust, or corrosive gases.

q KEEP IN A WELL VENTILATED PLACE !

DO NOT cover this monitor or place anything against any sides (not only the top, right

and left side but also the rear and bottom side) of unit.

Ventilation holes are provided at

all sides of the rear cover to prevent the temperature from rising.

n KEEP AWAY FROM HEAT SOURCES !

AVOID placing the unit in direct sunshine or near a heating appliance.

n BE CAREFUL OF MAGNETIC FIELDS !

DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything

which will generate magnetism near the unit. A magnetic field may cause blurred

or distortion of the displayed pattern.

n BE CAREFUL OF GENERATED MAGNETISM !

After the power has been turned on or “DEGAUSS” button has been pressed, the CRT is

demagnetised for approximately 10 seconds. This generates a strong magnetic field around the

front cover which may affect the data stored on magnetic tape or disks near the front cover.

Place such magnetic recording equipment and tapes/disks away from this unit.

AMBIENT ILLUMINATION

Avoid direct rays of the sun or room lighting onto the CRT screen in order to prevent eye fatigue.

n THE ENCLOSED POWER CORD MUST BE USED !

In Europe, a proper European standard approved power cord is to be used with this

monitor.

For a rated current up to 6 A, a type not lighter than

3G 0.75

or

3G 0.75

must be used.

In USA/Canada, use a UL

or CERTIFIED power cord set

meeting the following specifications

Rating: min.

7A

Length: max. 3.0 m

Type: SVT or SJT

Plug type: NEMA

5P figure, Parallel blade, Grounding type

Failure to do so may cause fire or electric shock hazard.

USE ONLY THE CORRECT VOLTAGE POWER OUTLET WITH SAFETY

GROUND CONNECTION !

100 120 V for USA, Canada, etc.

200 240 V for Europe, etc.
(This monitor will automatically adjust to the input voltage 100 240V.)

1 - 2