Hitachi CM650ET User Manual
Page 10
Install the monitor in the following way, taking care to maintain safety
FRONT VIEW
Control Panel
Tilt Swivel Base
Rear Cover
Signal Input
Connector
AC Inlet
Power Cord
REAR VIEW
USB Slot
to a receptacle of
to
the host
computer
(for
the
optional
USB HUB Module)
the correct voltage
1. Installation
Install the monitor on a horizontal base.
2. Power Cord Connection
Make sure of using the power cord meeting the safety standard of the country in
which you are using the monitor.
Insert the connector of a power cord to the AC Inlet of the monitor.
Insert the plug of the power cord to a power point of the correct voltage.
3. Signal Cable Connection
Insert the Signal Input Connector of the monitor to the host computer, with attention to
it’s suitability, and secure the screws on the connector shell firmly.
D-Sub Mini 1 B-pin Connector
4.
Power On
Turn on the Power Switch of the
monitor first, then the computer.
Refer to Page 1-8 “POWER ON/OFF”.
Pin No.
Signal
1
Red Video
11
Ground
12
Bi-directional Data
[SDA]
13
(or
14
15
Data Clock
[SCL]
l - 6