beautypg.com

Hitachi CM650ET User Manual

Page 12

background image

Power LED

Power Switch

Switches Switches

Switch

POWER

Press the Power switch, to switch the power ON or OFF.

n When power is ON, the power LED lights.
n After turning OFF the switch, wait at least 5 seconds before restarting the monitor.

Otherwise the monitor may operate incorrectly.

If the picture doesn’t appear, turn OFF the power switch, make sure of the following

and wait at least 30 seconds before restarting the monitor.

Make sure the power switch of the computer, power cord connection, signal cable

connection and the input sync. signal are correct.

CONTROL

Press the Status switch. The On Screen Display function of

then shows

the selected function, its condition, the function menu and the input signal
frequencies.

n You can select the

language.

Use the function “LANGUAGE SELECT”.

To select the function, use the Function

switches.

To execute the selected function, use the

Adjust Switches in the Table-l overleaf.

n You can save the your geometry and

settings.

Refer to “SAVE” below.

. . .

Sample

of

n To clear the

either push the status

switch again or wait for 10 seconds.

SAVE

If the function “AUTO SAVE” is ON, you can save automatically at clearing the

l - 8