beautypg.com

Input signal screen display, English, 2 pictures (split) – Hitachi CMP420V1 User Manual

Page 39

background image

ENGLISH

OPERATING INSTRUCTIONS (continued)

Displaying MULTI PICTURE

If the PinP button on the remote control is pressed MULTI
PICTURE will display.

Activating the P-in-P mode from the RGB input screen

Pressing the PinP button one time will display 2 pictures.

• This mode can be available from RGB1(DVI-PC) and RGB2(RGB)

input.

• The speaker icon can be shifted up and down by pressing the

and

SELECT buttons; the audio of the video will be output from

the side on which the speaker icon is located.

• The sub-screen position can be

selected up and down by pressing

SELECT buttons.

• The sub-screen can be selected with

the AV1, AV2, AV3, and AV4 buttons
from the status that the speaker icon
appears on the left side of AV

as

shown in the diagram to the right.

• Pressing the PinP button again or

the RETURN button will cancel the 2 pictures display.

• "Frequency Mode" in the Setup Menu should be set to Movie when

sub-screen is the component signal of 1080i/50 or 1080i/60.

AV1: Displays the VIDEO input signal of the sub-screen.

Activating the Split mode from the video input screen

Pressing the PinP button one time will display 2 pictures.

• The speaker icon can be shifted left

and right by pressing the

and

SELECT buttons; the audio of the
video will be output from the side on
which the speaker icon is located.

• The same video input mode cannot

be selected for both screens at the
same time.

• Pressing the PinP button again or

the RETURN button will cancel the 2
pictures display.

• When the Video input is set to RGB Video, this Split mode is not possible.
• Refer to the table for 2 pictures (Split) mode.

PinP button

RETURN button

AV1

AV2

RGB 1

RGB 2

AV3

MUTE

VOL

VOL

AV4

AUTO

PinP

OK

SIZE

RECALL

MENU

ID

ID SET

RECALL button

RGB2

AV1

(Sub-
screen)

AV1

AV2

RECALL button

2 Pictures (Split)

Main

Sub

The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control or
the monitor.

• The display will go out in approximately 6 seconds.

AV1

Composite

-- -- Min.

-- -- : -- --

OFF

Input Signal Screen Display

Input mode
Signal mode

Off-timer
On-timer

VIDEO

NOTE

• Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not

change to power save mode.

• Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.

Input terminal

AV1

AV4

AV1, AV2

RGB1

RGB2

PAL-N

NTSC-M

PAL-M

576i

576p

480i

480p

1080i/50 1080i/60 720p/60

STB

Component

AV1

AV4

PAL-N

NTSC-M , PAL-M

AV1
AV2

576i, 576p

480i, 480p

1080i/50

1080i/60

720p/60

RGB1

STB

RGB2

Component

(

Main

Sub