Wolf 15 Inch Transitional Induction Cooktop Installation Instructions - Manual (Page 5)

wolfappliance.com | 5
WARNING
The complete appliance must be properly grounded at
all times when electrical power is applied.
Do not ground appliance with the neutral (white) house
supply wire. A separate ground wire must be utilized.
If aluminum house supply wiring is utilized, splice the
appliance copper wire to the aluminum house wiring
using special connectors design and agency certified
for joining copper and aluminum. Follow the connector
manufacturer's recommended procedure carefully.
Improper connection can result in a fire hazard.
SPECIFICATIONS
Induction cooktop.
Electric cooktop.
RATING PLATE RATING PLATE
Electrical
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustrations
on the following pages. A separate circuit, servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
When multiple cooktops are installed side by side, each unit
must have its own separate recommended electrical circuit.
ELECTRICAL REQUIREMENTS
INDUCTION
Electrical Supply 3-wire, 240/208 VAC, 60 Hz
Conduit flexible 4' (1.2 m)
ELECTRIC
Electrical Supply 3-wire, 240 VAC, 60 Hz
Conduit flexible 4' (1.2 m)
SERVICE
15" Induction / Electric 20 amp dedicated circuit
24" Induction 30 amp dedicated circuit
30" Induction / Electric 40 amp dedicated circuit
36" Induction / Electric 50 amp dedicated circuit