Elac Varro Dual Reference DS1000 10" 2000W Subwoofer (Gloss Black) - Manual (Page 7)

Page 6
Wireless Pairing
Included with your subwoofer are four optional spikes that
can be used` when the subwoofer is used on carpet.
If you are installing the subwoofer onto hardwood, tile or
other non-carpeted surfaces please use spike discs (Not
included), or do not install the spikes to prevent any dam-
age to your floor.
1. Attach the spikes by screwing them into the threaded inserts on each of the four cor-
ners on the bottom of the subwoofer.
2. The nut on the spike is used to the lock the spike at the desired height.
Optional Spike Installation
Note:
This subwoofer has a built in wireless receiver intented
to work with ELAC AirX2 transmitter.
Pairing the wireless transmitter with other AirX2 products is very simple. Please follow the below steps
to complete the process.
1. Press and hold the Wireless Pair button on the subwoofer until the LED begins to flash rapidly
(Around 2 times per second).
2. Press and hold the Wireless Pair button on the bottom of the AirX2 transmitter until the wireless pair
LED on the subwoofer stops flashing and stays solid blue. A solid blue LED means the subwoofer
paired properly. The LED being off means the subwoofer did not pair and please try again.
3. Repeat with additional subwoofers (Up to 3 units)
Filename: elac 1019_10PR amp panel silk Rev B.ai
1 Color: White
SCI P/N: SLK3550
Rev: B
ON
OFF
POWER
T12A H 250V
T6.3A H 250V
RIGHT
LEFT
SPEAKER LEVEL
INPUTS
VOLUME
SERVICE
LINE
IN
LEFT RIGHT/
LFE
ETHERNET
12V
TRIGGER
LEFT
RIGHT
Dual Reference Subwoofer Series
Model : DS1000-GB
CONTAINS FCC ID: A8TBM70ABCDEFGH
CONTAINS IC ID: 12246A-BM70BLES1F2
CONTAINS FCC ID: NKR-SWA12
CANTAINS IC: 4441A-SWA12
CAN ICES-3(B)/NMB-3(B)
THIS DEVICES COMPLIES WITH PART 15 OF THE FCC RULES
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATIONS
SERIAL NUMBER
Desinged by Elac Made in China
CAUTION
For continued protection against
risk of fire, replace only with same
type fuse and rating
ATTENTION
Utiliser un fisible de rechange
de meme type et calibre
100-120VAC 50/60Hz 12A 220-240VAC 50/60Hz 6.3A
1938 N. Batavia St. Suite K
Orange, CA 92865
Fraunhoferstraße 16
24118 Kiel
Deutschland
www.elac.com
WIRELESS
PAIR/RESET
ELAC Dual Reference Subwoofer Models DS1000, DS1200 | www.elac.com