Elac Varro Dual Reference DS1000 10" 2000W Subwoofer (Gloss Black) - Manual (Page 6)

Firmware Update
Note:
Firmware for your subwoofer can be downloaded from
www.elac.com under the troubleshooting and firmware
section.
USB drive must be compatible with USB 2.0 with a 512
byte hardware sector size.
1. Unzip the downloaded firmware file and place the “FIRMWARE_UPDATE_FILE.BL2”
file in the root directory of a FAT32 formatted USB flash drive. exFAT, NTFS and other
file systems are not compatible.
2. Power off the subwoofer, wait 5 seconds and plug the USB flash drive into the USB
port on the rear of the subwoofer.
3. Power on the Subwoofer. The firmware update will automatically begin.
4. The firmware update will be complete when the LED on the rear of the subwoofer
stops flashing.
5. Power Cycle the subwoofer. The firmware update is now complete.
6. You can check the firmware version of the subwoofer in the Sub Control 3.0 app on
the about page.
Reset
1. Press and hold down RESET button for minimum of 10 seconds
2. LED starts to blink (flash). LED blinking parameters: LED is on for 100 ms (milliseconds) then LED is off
for 100 ms.
3. Release the RESET button before 15 seconds elapses in order to force the sub to perform Factory
Reset
4. If the RESET button is hold down for more than 15 seconds Factory Reset is cancelled.
Page 5
Filename: elac 1019_10PR amp panel silk Rev B.ai
1 Color: White
SCI P/N: SLK3550
Rev: B
ON
OFF
POWER
T12A H 250V
T6.3A H 250V
RIGHT
LEFT
SPEAKER LEVEL
INPUTS
VOLUME
SERVICE
LINE
IN
LEFT RIGHT/
LFE
ETHERNET
12V
TRIGGER
LEFT
RIGHT
Dual Reference Subwoofer Series
Model : DS1000-GB
CONTAINS FCC ID: A8TBM70ABCDEFGH
CONTAINS IC ID: 12246A-BM70BLES1F2
CONTAINS FCC ID: NKR-SWA12
CANTAINS IC: 4441A-SWA12
CAN ICES-3(B)/NMB-3(B)
THIS DEVICES COMPLIES WITH PART 15 OF THE FCC RULES
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATIONS
SERIAL NUMBER
Desinged by Elac Made in China
CAUTION
For continued protection against
risk of fire, replace only with same
type fuse and rating
ATTENTION
Utiliser un fisible de rechange
de meme type et calibre
100-120VAC 50/60Hz 12A 220-240VAC 50/60Hz 6.3A
1938 N. Batavia St. Suite K
Orange, CA 92865
Fraunhoferstraße 16
24118 Kiel
Deutschland
www.elac.com
WIRELESS
PAIR/RESET
Filename: elac 1019_10PR amp panel silk Rev B.ai
1 Color: White
SCI P/N: SLK3550
Rev: B
ON
OFF
POWER
T12A H 250V
T6.3A H 250V
RIGHT
LEFT
SPEAKER LEVEL
INPUTS
VOLUME
SERVICE
LINE
IN
LEFT RIGHT/
LFE
ETHERNET
12V
TRIGGER
LEFT
RIGHT
Dual Reference Subwoofer Series
Model : DS1000-GB
CONTAINS FCC ID: A8TBM70ABCDEFGH
CONTAINS IC ID: 12246A-BM70BLES1F2
CONTAINS FCC ID: NKR-SWA12
CANTAINS IC: 4441A-SWA12
CAN ICES-3(B)/NMB-3(B)
THIS DEVICES COMPLIES WITH PART 15 OF THE FCC RULES
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATIONS
SERIAL NUMBER
Desinged by Elac Made in China
CAUTION
For continued protection against
risk of fire, replace only with same
type fuse and rating
ATTENTION
Utiliser un fisible de rechange
de meme type et calibre
100-120VAC 50/60Hz 12A 220-240VAC 50/60Hz 6.3A
1938 N. Batavia St. Suite K
Orange, CA 92865
Fraunhoferstraße 16
24118 Kiel
Deutschland
www.elac.com
WIRELESS
PAIR/RESET
Note:
RESET erases all data and restores subwoofer firm-
ware and parameters to the original factory settings.
Firmware upgrade may be necessary post RESET.
ELAC Dual Reference Subwoofer Models DS1000, DS1200 | www.elac.com