Vivotek S Series IZ9361-EH 1080p Outdoor Network Bullet Camera with Heater - Manual (Page 435)

VIVOTEK
User's Manual - 435
© 2020 VIVOTEK INC. All Right Reserved
280
8.28 Preset Locations
(capability_camctrl_c<0~(n-1)>_zoommodule = 1)
Note: This request requires Operator privileges.
Method: GET/POST
Syntax:
http://<
servername >/cgi-bin/operator/preset.cgi?[channel=]
[&addpos=][&delpos=][&return= ]
PARAMETER
VALUE DESCRIPTION
addpos string[30] Add one preset location to the preset list.
channel 0~"capability_nvideoin"-1 Channel of the video source.
delpos string[30] Delete preset location from preset list.
return Redirect to the page after the parameter
is assigned. The should be the relative
path according to the root of camera. If you omit this
parameter, it will redirect to an empty page.
* If the is invalid path, it will ignore this
parameter.
8.29 SmartSD (capability_localstorage_smartsd > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://<
servername >/cgi-bin/admin/smartsd.cgi?function=
© 2020 VIVOTEK INC. All Right Reserved
281
PARAMETER VALUE
DESCRIPTION
function getstatus Function type
getstauts : Information of smartSD internal status return
value as below:
smartsd_lifetime_num :
Accumulated amount of data that has been written
smartsd_lifetime_den :
Card-guaranteed amount of data that can be written
smartsd_lifetime_rate :
The ratio of smartsd_lifetime_num to
smartsd_lifetime_den.
It means the accumulated percentage amount of flash
block has been written. The range is from 0 to 100 (unit: %).
The SD card is recommended to be replaced if the
percentage reaches above 90%.
smartsd_spare_block_rate :
Usage rate of spare blocks.
It means the usage percentage of total spare block. The
range is from 0 to 100 (unit: %). The SD card is
recommended to be replaced if the percentage reaches
above 90%.
smartsd_data_size_per_unit :
Size (in sectors) of data to be written when Life
Information1 is updated.
smartsd_num_of_sudden_power_failure :
Indicates how many times power disconnection occurred during write/erase
operations
smartsd_operation_mode :
Enables/disables power-off detection and write error notification
smartsd_attached :
Indicate the smartSD is attached or not.
8.30 Connect to AP (capability_network_wireless > 0)
Note: This request requires Administrator privileges.
Method: GET/POST