Vivotek S Series IZ9361-EH 1080p Outdoor Network Bullet Camera with Heater - Manual (Page 411)

VIVOTEK
User's Manual - 411
© 2020 VIVOTEK INC. All Right Reserved
256
PARAMETER VALUE DESCRIPTION
addpos 40 characters> Add one preset location to the preset list.
delpos 40 characters> Delete preset location from the preset list.
return Redirect to the page after the parameter is
assigned. The should be the relative path
according to the root of camera. If you omit this
parameter, it will redirect to an empty page.
* If the is invalid path, it will ignore this
parameter.
8.10 IP Filtering for ONVIF
Syntax:
http://< servername >/cgi-bin/admin/ipfilter.cgi?type[=]
http://< servername >/cgi-bin/admin/ipfilter.cgi?method=add&ip= [&index=
ue>][&return=< return page >]
http://< servername >/cgi-bin/admin/ipfilter.cgi?method=del&index=[&return=< retu
rn page >]
PARAMETER
VALUE DESCRIPTION
type NULL Get IP filter type
allow, deny Set IP filter type
method addv4 Add IPv4 address into access list.
addv6 Add IPv6 address into access list.
delv4 Delete IPv4 address from access list.
delv6 Delete IPv6 address from access list.
ip Single address:
Network address:
Range address:
index The start position to add or to delete.
8.11 UART HTTP Tunnel Channel (capability_nuart > 0)
Note: This request requires Operator privileges.
Method: GET and POST
© 2020 VIVOTEK INC. All Right Reserved
257
Syntax:
http://<
servername >/cgi-bin/operator/uartchannel.cgi?[channel=]
-------------------------------------------------------------------------
GET /cgi-bin/operator/uartchannel.cgi?[channel=]
x-sessioncookie: string[22]
accept: application/x-vvtk-tunnelled
pragma: no-cache
cache-control: no-cache
-------------------------------------------------------------------------
POST /cgi-bin/operator/uartchannel.cgi
x-sessioncookie: string[22]
content-type: application/x-vvtk-tunnelled
pragma : no-cache
cache-control : no-cache
content-length: 32767
expires: Sun, 9 Jam 1972 00:00:00 GMT
User must use GET and POST to establish two channels for downstream and upstream. The
x-sessioncookie in GET and POST should be the same to be recognized as a pair for one session. The
contents of upstream should be base64 encoded to be able to pass through a proxy server.
This channel will help to transfer the raw data of UART over the network.
Please see UART tunnel spec for detail information
PARAMETER
VALUE DESCRIPTION
channel 0 ~ (n-1) The channel number of UART.
8.12 Event/Control HTTP Tunnel Channel
(capability_evctrlchannel > 0)
Note: This request requires Administrator privileges.
Method: GET and POST
Syntax:
http://<
servername >/cgi-bin/admin/ctrlevent.cgi