6 upgrade firmware – Vivotek MD9584-HF3 5MP Outdoor Network Mobile Dome Camera with Night Vision, Heater & 3.6mm Lens User Manual

Page 399

VIVOTEK

User's Manual - 399

268

ERROR: Update user's privilege fail!

8.6

Upgrade Firmware

Note:

This request requires Administrator privileges.

Method: POST

Syntax:

http://<

servername

>/cgi-bin/admin/upgrade.cgi

Post data:
fimage=[&return=]\r\n
\r\n

Server will accept the file named to upgradethe firmware and return with page> if indicated.

269

8.7

ePTZ Camera Control

(capability_eptz > 0 and

Capability_fisheye = 0)

Note:

This request requires camctrl privileges.

Method:

GET/POST

Syntax:
http://<

servername

>/cgi-bin/camctrl/eCamCtrl.cgi?channel=&stream=

[&move=] – Move home, up, down, left, right
[&auto=] – Auto pan, patrol
[&zoom=]

–

Zoom in, out

[&zooming=&zs=] –Zoom without stopping, used for joystick
[&x=&y=&w=&h=&resolution=] - Zoom in, out on a specific
area
[&vx=&vy=&vs=] – Shift without stopping, used for joystick
[&x=&y=&videosize=&resolution=&stretch=]

–

Click on

image

(Move the center of image to the coordination (x,y) based on resolution or videosize.)
[ [&speedpan=][&speedtilt=][&speedzoom=][&speedapp=

value

] ]

– Set

speeds

[&return=]

Example:

http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=0&move=right
http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=1&vx=2&vy=2&vz=2
http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=1&x=100&y=100&
videosize=640x480&resolution=640x480&stretch=0

In zoom operation, there are two ways to control it, scale zoom and area zoom.

1. [Scale zoom]: contains two control method, relative movement and continuous movement
a. relative movement -
If you trigger a relative movement, it will only zoom certain ratio and stop by itself.
http://IPAddr/cgi-bin/camctrl/eCamCtrl.cgi?stream=0&zoom=tele

http://IPAddr/cgi-bin/camctrl/eCamCtrl.cgi?stream=0&zoom=wide

The zoom ratio to move by relative movement is according to the setting of speedzoom [-5~5].
http://IPAddr/cgi-bin/camctrl/eCamCtrl.cgi?stream=0&speedzoom=5