Bushnell Prime Low-Glow Trail Camera Kit (Gray) User Manual
Page 15

15
The SETUP Menu – Parameters and Setting List w / Descriptions
Parameter
Settings
(Bold=default)
Description
Set Clock
Set
Press OK and use the UP/DOWN
keys (to change the setting) and
LEFT/RIGHT keys ( to move to the
next field) to set the hour (24-hr format
only, “00”=midnight, “12”=noon) and
minute, and then (on the lower row),
the year, month and date.
Mode
Camera
or Video
Selects whether still photos or video
clips are captured when the camera
is triggered.
Interval
5S
(second) default, with
a 60M (minute) to 1S
(second)
range of settings
available.
(60M-1M are set in one
minute increments,
59S-1S are set in one
second increments)
Selects the length of time that the
camera will “wait” until it responds to
any additional triggers from the PIR
after an animal is first detected and
remains within the sensor’s range.
During this user set “ignore triggers”
interval, the camera will not capture
photos/videos. This prevents the
card from filling up with too many
redundant images. Settings begin
with the default 5 seconds when
parameter is first selected.
Notes: after setting down past “1S”,
settings start over at “60M”.
Setting the Interval time to 1 second
will capture the maximum # of
images, but some may appear
"washed out" if animal is too close to
camera at night.
Addition Set
On or
Off
Select ON to access to the full suite
of settings.