Marantz Stereo 70S 2.1-Channel Network A/V Receiver - Manual (Page 178)

No sound comes out
No sound comes out of speakers.
0
This unit supports analog audio signals and PCM 2-channel signals. To play sources such as Dolby Digital discs, set “PCM 2ch” as the audio format in
the audio device settings.
0
Check the connections for all devices. ( v p. 28)
0
Insert connection cables all the way in.
0
Check that input connectors and output connectors are not reversely connected.
0
Check cables for damage.
0
Check that speaker cables are properly connected. Check that cable core wires come in contact with the metal part on speaker terminals. ( v p. 28)
0
Securely tighten the speaker terminals. Check speaker terminals for looseness. ( v p. 28)
0
Check that a proper input source is selected. ( v p. 53)
0
Adjust the volume. ( v p. 54)
0
Cancel the mute mode. ( v p. 54)
0
Check the digital audio input connector setting. ( v p. 140)
0
Check the digital audio output setting on the connected device. On some devices, the digital audio output is set to off by default.
0
When a headphone is plugged into the PHONES jack on the main unit, sound is not output from the speaker terminal and PRE OUT connector.
0
Check the settings for the SPEAKERS switching knob.
No sound comes out when using the DVI-D connection.
0
When this unit is connected to a device equipped with a DVI-D connector, no sound is output. Make a separate audio connection.
Contents Connections Playback Settings Tips Appendix
178
Front panel Display Rear panel Remote Index