MakerBot METHOD X 3D Printer - Manual (Page 22)

MAK
E
R
B
OT
M
E
TH
O
D
MAN
U
AL
PA
G
E
2
2
INFO
Select the [INFO] icon to view firmware information, network information, and print statistics from your
MakerBot Method.
EXTRUDER
Select the [EXTRUDER] icon for assistance in attaching a Performance Extruder. If the Performance Extruder is
attached, the screen will show the Performance Extruder information such as temperature and print statistics.
If the Performance Extruder is not attached, the Extruder icon will not be highlighted or display the MakerBot logo.
When attaching the Performance Extruder, position the extruder so that the connectors lock into place with the
Extruder Assembly and close the latch onto the extruder. If the Performance Extruder is successfully attached, you
will see the extruder icon highlighted.
NOTE: Only the Performance Extruder is supported for the MakerBot Method. Both extruders are required to start a print.
RESET TO FACTORY SETTINGS
Select [RESET TO FACTORY SETTINGS] to restore the MakerBot Method to its original factory settings and wipe
any information stored on the internal storage drive.
POWER OFF
Select [POWER OFF] on the touchscreen to turn off the MakerBot Method.