MakerBot METHOD X 3D Printer - Manual (Page 12)

MAK
E
R
B
OT
M
E
TH
O
D
MAN
U
AL
PA
G
E
1
2
Carefully remove the foam from
the sides of the printer.
Remove the bag, remaining
packaging tape, and open the
door to remove the starter kit.
Use the correct power cord
to connect the printer to an
accessible outlet.
Lift the lid off and store nearby.
Open the starter kit on a flat
surface.
Press the power button on the
front of the printer.
With two people lift from the side
handles of the printer and put it
on a stable flat surface.
Locate the power input on the
lower back of the printer.
After the printer powers on,
follow the on screen instructions
to finish setting up your printer.
UNPACKING THE METHOD
Carefully remove the foam from
the sides of the printer. Lift the lid off and store nearby.
Remove the bag, remaining
packaging tape, and open the
door to remove the starter kit.
With two people lift from the
side handles of the printer and
put it on a stable flat surface.
Open the starter kit on a flat
surface.
Use the correct power cord to
connect the printer to an
accessible outlet.
Locate the power input on the
lower back of the printer.
Press the power button on the
front of the printer. After the printer powers on, follow
the on screen instructions to finish
setting up your printer.
1 2 3
4 5
7 8 9
UNBOXING
6
US/CAN Call: +1 925.529.8563 Mon - Fri 9am – 6pm ET
Or Visit: Support.MakerBot.com
International: MakerBot.com/Service-Partners
NEED HELP?
Carefully remove the foam from
the sides of the printer. Lift the lid off and store nearby.
Remove the bag, remaining
packaging tape, and open the
door to remove the starter kit.
With two people lift from the
side handles of the printer and
put it on a stable flat surface.
Open the starter kit on a flat
surface.
Use the correct power cord to
connect the printer to an
accessible outlet.
Locate the power input on the
lower back of the printer.
Press the power button on the
front of the printer. After the printer powers on, follow
the on screen instructions to finish
setting up your printer.
1 2 3
4 5
7 8 9
UNBOXING
6
US/CAN Call: +1 925.529.8563 Mon - Fri 9am – 6pm ET
Or Visit: Support.MakerBot.com
International: MakerBot.com/Service-Partners
NEED HELP?
Carefully remove the foam from
the sides of the printer. Lift the lid off and store nearby.
Remove the bag, remaining
packaging tape, and open the
door to remove the starter kit.
With two people lift from the
side handles of the printer and
put it on a stable flat surface.
Open the starter kit on a flat
surface.
Use the correct power cord to
connect the printer to an
accessible outlet.
Locate the power input on the
lower back of the printer.
Press the power button on the
front of the printer. After the printer powers on, follow
the on screen instructions to finish
setting up your printer.
1 2 3
4 5
7 8 9
UNBOXING
6
US/CAN Call: +1 925.529.8563 Mon - Fri 9am – 6pm ET
Or Visit: Support.MakerBot.com
International: MakerBot.com/Service-Partners
NEED HELP?