Ilford SFX 200 Black and White Negative Film (35mm Roll Film, 36 Exposures) - Manual (Page 6)

Page 6 of 6 Nov 2018
SFX 200 Technical Information
Fix
The recommended fixers are ILFORD RAPID
FIXER or ILFORD HYPAM FIXER.
Wash
Wash the films in running water for 5–10
minutes at a temperature within 5ºC (9ºF) of
the process temperature. Or see note below
for greater economy when using spiral tanks.
Note: For spiral tank use, the following method of washing is recommended. This method of washing is faster,
uses less water yet still gives negatives suitable for long term storage.
After fixing, fill the spiral tank with water at the same temperature, ± 5ºC (9ºF), as the processing solutions and
invert it five times. Drain the water away and refill. Invert the tank ten times. Once more drain the water away
and refill. Finally, invert the tank twenty times and drain the water away.
Rinse
For a final rinse use ILFORD ILFOTOL wetting agent added to water, it helps the film to dry rapidly and evenly.
Start by using 5ml per litre of rinse water (1+200), however the amount of ILFOTOL used may need some
adjustment depending on the local water quality and drying method. Too little or too much wetting agent can
lead to uneven drying. Remove excess rinse solution from the film before drying.
Drying
To avoid drying marks, use a clean squeegee or chamois cloth to wipe SFX 200 film before hanging it to dry.
Dry SFX 200at 30–40°C/86-104°F in a drying cabinet or at room temperature in a clean dust-free area.
STORAGE
For immediate use, store SFX 200in a cool (10–20°C/50-68°F), dry place in its original packaging.
SFX 200 may be stored in a fridge/freezer but allow plenty of time for the film to acclimatise prior to use.
Exposed film
Once exposed, process SFX 200 as soon as practical.
Exposed films should always be stored in cool, dry conditions - as recommended above.
Negatives
Store processed negatives in a cool (10–20°C/50-68°F), dry place, in the dark. Suitable storage sleeves
include those made of cellulose triacetate, Mylar, paper (pH6.5–7.5) or inert polyester.
A wide range of fact sheets is available which describe and give guidance on using ILFORD PHOTO products.
Some products in this fact sheet might not be available in your country.
HARMAN
technology Limited , Ilford Way, Mobberley,
Knutsford, Cheshire WA16 7JL, England
www.ilfordphoto.com
ILFORD RAPID OR HYPAM FIXERS
Dilution 1+4
Temperature Range 18–24ºC (64–75ºF)
Time (mins) at 20ºC (68ºF) 2-5
Capacity (films per litre,
unreplenished)
24x (135-36)