Nissin Di700A Flash for Micro Four Thirds Cameras - Manual (Page 17)

Di700A supports shutter speeds up to 1/8,000 second.
In A, M, TTL mode:
Enable on Di700A
ON: Press and hold Pilot button in 3 seconds.
Pilot button starts blinking twice.
OFF: Press and hold Pilot button in 3 seconds to cancel the
setting .
In Wireless Remote Mode - Optical Transmission:
Enable High-speed sync on Master Unit.
In Wireless Remote Mode - Radio Transmission (NAS)
Enable High-speed sync on Commander (please refer to NAS
Commander user’s manual).
High-speed mode use higher flash energy. To protect the flash
from overheat. The recycling time will be extended to a minimum
7 seconds.
To reset the flash unit to
another mode, press the
mode select button for TTL
and or Manual mode.
Energy saving system for stand-by mode will not work when it's in
slave mode.
Automatic shut off function is however in effect. It automatically
turns-off when not in use for over 60 minutes.
The zoom setting position is
automatically set for the focal
length of 35mm while using
Di700A as a slave unit.
Set the camera for flash shooting mode. Point at the subject and
shoot. The slave flash will synchronize to the master flash and
gives additional lighting from the different direction you desired.
Shooting the subject
HSS High-Speed Synchronization
16