Godox VING V860IIC TTL Li-Ion Flash Kit for Cameras - Manual (Page 17)

5. ETTL: Use the Wireless Shooting of Flash Ratio
Auto Flash Shooting with Two Slave Unit
Divide the slave units into A and B groups and balance their shooting
illumination (flash ratio).
Auto control exposure to make the total output of A and B flash
groups up to standard exposure.
Setting the flash groups of 1
slave unit.
● Set the flash as slave unit.
● Press Function Button 3
< > and choose
< A > or < B >.
● Set one slave unit as < A >,
the other as < B >.
Gr
MENU 2
RATIO
Setting < >. 2
● Step 2 to Step 4 are set on
the master unit.
● Press the Function Button
4 on the master unit so that
< > is displayed. MENU 2
Setting . 3
● Press Function Button 2
< > so that
< RATIO A:B > is displayed.
Setting flash ratio.
4
● Press Function Button 3
< >.
● Turn the Select Dial to set
the amount of flash ratio
and press< SET > button to
confirm.
Taking the picture. 5
● The slave units will flash
according to the flash ratio.
Gr
Auto Flash Shooting with Three Slave Unit
Setting . 2
● Use the same method of
step 1 and step 3 (Page
71) to set the master unit
as < RATIO A:B C >.
Setting the slave group 1
.
● Use the same method of
step 1 (Page 71) to set the
slave unit of flash
group< C >.
Setting flash exposure 3
compensation.
● Use the same method of
step 1 (Page 71) to set the
slave unit of flash
group< C >.
● Press Function Button 2
< >. Turn the Select
Dial to set the amount of
flash exposure
compensation and
press< SET > button to
confirm.
A B
C
About Slave Group Control
If three slave units are all set to
< A > in terms of slave ID, these
slave units will be controlled as if
they were one camera flash in
slave group A.
● When setting < RATIO A:B C >, group A, B and C will fire a
flash synchronously; when setting< RATIO A:B >, group C
will not fire a flash.
● If shooting under the situation that group C is toward the
main shooting subject, over exposure might occurred.
● In some EOS film cameras that support E-TTL autoflash,
you cannot perform multiple flash wireless shooting with a
flash ratio setting.
ID = A ID = A ID = A
Slave Group A
● The flash ratio of 8:1 to 1:1 to 1:8 is equivalent to 3:1 to 1:1
to 1:3 (1/2 step increment).
● The details of the flash ratio settings are as follows.
8:1 4:1 2:1 1:1 1:2 1:4 1:8
5.6:1 2.8:1 1.4:1 1:1.4 1:2.8 1:5.6
6. M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash. You
can shoot with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
Setting the flash mode to 1
.
- 71 - - 72 -