Godox TT350F Mini Thinklite TTL Flash for Cameras User Manual
Page 9
Check the communication
3
channel
●
If the master unit and
slave unit(s) are set to a
different channel, set them
to the same channel.
(Page 38)
Position the camera and
4
flashes
●
Position the camera and
flashes as the picture
shows. (Page 40)
Check the flash operation
5
●
Press the master unit’s
Test Button< >
.
●
Then, the slave unit will
fire. If not, adjust the slave
unit’s angle toward the
master unit and distance
from the master unit.
The slave unit might be out of order or fire an unwanted flash
due to the nearby wifi routers or other 2.4G equipments. If in
this case, please adjust the flash’s channel or turn off the 2.4G
equipments.
MODE
ZOOM
SYNC
SLAVE
SET
5. M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash. You
can shoot with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
Setting the flash mode to
1
●
Press the <
MODE
> Button
to set the flash to M mode.
Setting flash output
2
●
Turn the Select Dial to set
the flash output of the
groups.
Taking the picture
3
●
Each group fires at the set
flash ratio.
MODE
ZOOM
SYNC
SLAVE
SET
MODE
ZOOM
SYNC
SLAVE
SET
Setting
1
stroboscopic flash.
●
Long press the <
MODE
>
button for 2 seconds so that
<
Multi
> is displayed. Long
press the <
MODE
> button
for 2 seconds again to exit.
Using a flash (master/slave) with a radio transmission wireless
shooting function make it easy to shoot with advanced wireless
multiple flash lighting, in the same way as TTL autoflash shooting.
The basic relative position and operation range are as shown in the
picture. You can then perform wireless TTL autoflash shooting just
by setting the master unit to <
TTL
>.
6. Multi: Wireless Flash Shooting with Manual
Flash
Setting flash output/flash
2
frequency/flash times.
●
Setting the flash
output/flash frequency/flash
times of the groups in the M
mode. Setting the multi flash
mode. (see Page35 )
●
A, B and C group can only
control the ON/OFF of the
slave unit by pressing the
<
MODE
> Button.
MODE
ZOOM
SYNC
SLAVE
SET
Transmission distance is about 30m.
● Use the supplied mini stand to position the slave unit.
● Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on
the conditions such as positioning of slave units, the
surrounding environment and whether conditions.
Slave/Master Unit's Positioning and Operation Range
●
Autoflash Shooting with One Slave Unit
- 39 -
- 40 -