Godox TT350F Mini Thinklite TTL Flash for Cameras - Manual (Page 11)

● Point the flash head straight ahead and then upward by 90°.
The catchlight will not appear if you swing the flash head left
or right.
● For best catchlight effect, stay 1.5m/4.9ft away from the
subject.
ZOOM: Setting the Flash Coverage and Using
the Wide Panel
The flash coverage can be set automatically or manually. It can be
set to match the lens focal length from 24 to 105mm (135 format)
/16 to 56mm (APS). Also, with the built-in wide panel, the flash
coverage can be expanded for 14mm wide-angle lenses.
In Manual Zoom mode, press the
button.
● Turn the Select Dial to change
the flash coverage.
● AU If < > is displayed, the flash
coverage will be set
automatically.
● If you set the flash coverage manually, make sure it covers
the lens focal length so that the picture will not have a dark
periphery.
● When the low battery indicator is displayed, the ZOOM can
not be adjusted, it will constantly be 16mm.
● Choose 135 format or APS in the C.Fn-AP.
ZOOM SYNC SLAVE
SET
Using the Wide Panel
Pull out the wide panel and place it
over the flash head as shown. The
flash coverage will then be
extended to 14 mm.
● The catchlight panel will come
out at the same time. Push the
catchlight panel back in.
Low Battery Warning
If the battery power is low, < > will
appear and blink on the LCD panel.
Please replace the battery
immediately. When the low battery
indicator is displayed, the ZOOM can
not be adjusted, it will constantly be
16mm.
● When pull out the wide panel, the ZOOM will constantly be
12mm. The button will not work.
C.Fn: Setting Custom Functions
The following table lists the available and unavailable custom
functions of this flash.
ST
AF
BL
AP
ON
OF
ON
OF
10 sec.
OF
ON
ON
OFF
Auto sleep
(standby)
AF-assist beam
Backlighting
control
ZOOM display
format
C . Fn Custom Functions
Custom Function
Signs Function Setting No . Settings & Description
ON
OFF
ON
OFF
Off in 10 sec.
Always off
Always lighting
APS format
135 format
1 . Press the < ZOOM > Button for 2 seconds until C.Fn menu is
displayed.
2 . Turn the Select Dial to select the Custom Functions.
3 . Press the < SET > Button and the Setting No. blinks.
4. Turn the Select Dial to set the desired number. Pressing the
< SET > Button will confirm the settings.
5 . Press the < ZOOM > Button to exit.
Protection Function
1. Over-Temperature Protection
● To avoid overheating and deteriorating the flash head, do not fire
more than 30 continuous flashes in fast succession at 1/1 full
power. After 30 continuous flashes, allow a rest time of at least 10
minutes.
● If you fire more than 30 continuous flashes and then fire more
flashes in short intervals, the inner over-temperature protection
function may be activated and make the recycling time over 10
seconds. If this occurs, allow a rest time of about 10 minutes, and
the flash unit will then return to normal.
● When the over-temperature protection is started, is shown on
the LCD display.
- 43 - - 44 -