Bolt VD-420 Wireless Manual Flash - Manual (Page 26)

26 | Wired Camera Triggering
Wired Camera Triggering
You can connect the transmitter to your camera via a
PC sync to 2.5 mm cable (not included).
1. Plug a PC cord into your camera’s PC sync port
and the transmitter’s 2.5 mm sync input.
2. Press your camera’s shutter-release button to fire
the flash. The LED will flash red, and the flash will
fire to confirm signal transmission.
Note: Some camera models do not have PC ports. A
hot-shoe PC adapter is required for off-camera wired
connections.