Godox MF12 Macro Flash 2-Light Kit - Manual (Page 18)

Model
Built-in Lithium Battery
Guide No. (1/1 output)
Flash Power
Output Level
Brightness of LED Modeling Lamp
Display
Optical Flash
Flash Mode
Flash Duration
2.4G Wireless Transmission
Channel
Group
ID
Transmission Distance
Type-C Power Charging
Full Power Flashes
Recycle Time
Battery Level Indication
Power Saving
Dimension
Size
Net Weight
MF12
3.7V/6.29W
GN=16.1 (±0.1)
12W
8 levels: 1/128~1/1
1~10 Levels
OLED Display
S1 Secondary Optic Triggering
S2 Secondary Optic Triggering with Anti-preflash
TTL Autoflash, M manual flash
1/1200s~1/34000s
ON/OFF
32 channel: 1~32
5 group: A/B/C/D/E
OFF/01~99
30m
5V 2A
Approx. 500
Approx. 0.01~1.7s
Battery level indicator shows on the upper right corner of the display
30min/60min/90min It will automatically power off when
unattended operation over 30min/60min/90minutes.
OFF: Turn off auto power off mode,energy-saving performance is invalid.
81*76.5*64.3mm
≈144g
Technical Data Maintenance
- Shut down the device immediately should abnormal operation be detected.
- Avoid sudden impacts and the product should be dedusted regularly.
- It is normal for the light beads to be warm when in use. Avoid continuous flashes if unnecessary.
- Maintenance of the light must be performed by our authorized maintenance department which can provide
original accessories.
- This product, except consumables, is supported with a one-year warranty. Lithium battery is supported with
six months warranty.
- Unauthorized service will void the warranty.
- If the product had failures or was wetted, do not use it until it is repaired by professionals.
- Changes made to the specifications or designs may not be reflected in this manual.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Statement
- 31 - - 32 -