Bolt VM-160 LED Macro Ring Light - Manual (Page 14)

14 | Using the Diffusers
To dismount the VM-160 from your camera, make sure that it is turned off and follow these steps:
1. Press and hold the adapter ring locks to release the LED ring.
2. Rotate the locking wheel counterclockwise to release the power control.
3. Slide the mounting foot out of your camera’s hot shoe.
4. If desired, remove the adapter ring from your lens.
Mounting the VM-160 power control on the included stand:
You can mount the VM-160 power control unit on the included stand in the same way you would mount it on
your camera. This allows you to set it on a flat surface or to attach it to a tripod head, light stand, or clamp
that has a compatible 1/4
” -20 screw mount. Using your VM-160 in this manner will free up your camera’s hot
shoe.
Using the Diffusers
The VM-160 comes with four diffusers that modify the light output: clear, frosted white, blue, and amber. The
frosted white diffuser will produce a more diffused light than the clear one. The blue and amber diffusers will
cool and warm the light, respectively. Note that you will lose a bit of light with the blue and amber diffusers.