Pelco WMVE-SR Wall Mount - Manual (Page 5)

C2253M (1/11) 5
CONDUIT INSTALLATION
1. Using the wall mount as a template, mark the fastener positions on the mounting surface.
2. Prepare the mounting surface.
3. Remove the conduit cover from the bottom of the mount arm.
4. Route the wiring/cabling through the mount arm.
5. Thread a 3/4-inch conduit fitting (not supplied) into the conduit hole located at the bottom of the
mount arm.
6. Use a minimum of two 1/4-inch fasteners of appropriate type (not supplied) to secure the wall
mount to the mounting surface (refer to Figure 1 on page 4).
NOTE: (Outdoor installations only) Seal the fastener holes with an appropriate sealant (not supplied)
to prevent water damage. Be sure to apply the sealant between the mount and the mounting surface.
7. Attach the pendant mount adapter (not supplied) to the wall mount:
a. Route the wiring through the pendant mount adapter.
b. Apply anti-seize lubricant (supplied) to the threads of the pendant mount adapter.
c. Screw the pendant mount adapter onto the mount arm (refer to Figure 2 on page 4).
d. Use a 5/64-inch hex Allen wrench (not supplied) to tighten the setscrew located on the front
of the wall mount.
8. To complete the installation, refer to the manual supplied with the pendant mount adapter.