Impact Panel Frame Reflector Kit - Zebra Gold / Zebra Silver (59 x 82") - Manual (Page 6)

6
Setup - Part Two
1. Decide which surface you want
to use.
2. On the opposite side of the
reflector from the side you’re
using, install the two cross bars.
3. There are three gaps in the fabric
guides that hold the supporting
poles. Use the two gaps nearest
each end of the reflector to mount
a cross bar. Do not use the gap in
the middle for mounting a cross
bar.
1
4. Place the latch lock that’s on
the end of the cross bar onto the
support pole in a gap between
sections of the fabric guide near
the end of the reflector.
5. Seat the latch lock on the support
pole, and close the latch, locking
the end of the cross bar to the
support pole.
2
6. Place the other end of the cross
bar in the gap directly across the
reflector from the first one.
1 2