Bowers & Wilkins Px8 Noise-Canceling Wireless Over-Ear Headphones (Royal Burgundy) - Manual (Page 3)

3
ENGLISH
1. Px8 Carton Contents
Px8 over-ear wireless headphones
Storage case
USB-C to USB-C charging cable
USB-C to 3.5 mm audio cable
Document pack
2. Getting to Know Your Px8
We recommend installing the
Bowers & Wilkins
Music app on your iOS or Android
device. This allows
you to configure your
headphones in detail and
provides helpful hints and
tips to make the most of
your new headphones.
2.1 Switching Headphones On and Off
Diagram 1 illustrates power switch functionality.
Switching On
The power switch is located on the right earpiece.
Slide the power switch up to the middle position. An
audible cue will be played and the LED indicator will
light up.
Switching Off
Slide the power switch to the bottom position. An
audible cue will be played and the headphones will
power down when the LED indictor is no longer lit.
Bluetooth Pairing
Slide the power switch to the upper position and
hold for 5 seconds to enter Bluetooth pairing mode.
Refer to section 6 for further information on pairing
your headphones to a Bluetooth source.
2.2 Headphone Controls
Diagram 2 illustrates the headphone controls. The
buttons on the right earpiece are used for media
playback and telephony.
Media Playback
Function Action
Play or pause Press the Multi-function button once.
Play next
track
Press the Multi-function button
twice in quick succession.
Note:
functionality dependent on source
device.
Play previous
track
Press the Multi-function button three
times in quick succession.
Note:
functionality dependent on source
device.
Increase Volume Press the Volume + button.
Lower Volume Press the Volume - button.
Telephony
Function Action
Answer an
incoming call
Press the Multi-function button once.
End a call Press the Multi-function button once.
Decline an
incoming call Hold the Multi-function button for 2
seconds.
Switch between
two calls With two calls active, press the Multi-
function button twice.
Merge two calls
With two calls active, hold
the Multi-function button for
1 second.
Toggle mute
While on a call, press the Multi-
function button three times.
Diagram 2
Headphone controls
Quick Action button Volume -
Volume +
Power switch
Multi-function
Diagram 1
Power switch functionality
2.3 Status Indicator
The status LED indicator is located on the right
earpiece, the table below explains the illumination
states:
Illumination Operational state
White Battery charge > 30%
Amber Battery charge between 30% and 10%
Red Battery charge < 10%
Red flashing Battery charge insufficient for headphone operation
Blue flashing Pairing mode enabled
Blue (2 sec solid) Pairing successful
Blue flashing (calls) Incoming call
Green flashing Rapid charging
Green solid Battery charge full, trickle charging
bowerswilkins.com/downloadapp