Oben VH-A30 Tilt Head for Monopods - Manual (Page 6)

6
OPERATION OPERATION
1. Screw the head onto your
monopod.
2. Once attached, make sure the
head’s base is flush against
the monopod’s top mount.
3. If your monopod has a set
screw, tighten it until secure.
Mounting the Head to a Monopod
Mounting the Quick-Release Plate
The plate’s 1/4-20 screw will fit
most cameras and lenses.
1. Mount the quick-release plate
to the threaded socket of your
camera or lens base.
2. Tighten the screw with a coin
or a hex key, and make sure
the camera or lens base is
flush against the plate.
3. Fold the thumbscrew flat
against the bottom of the
plate before mounting it into
the clamp.