Godox AD200 TTL Pocket Flash with Barndoor Kit - Manual (Page 6)

Battery Level Indication
on the AV Panel
3 grids
2 grids
1 grid
Blank grid
Blinking
Meaning
Full battery
Medium battery
Low battery
Lower battery, please recharge it.
The battery level is going to be used out immediately. And the flash will auto power off
in 1 minute. Note: Please recharge the battery as soon as possible (within 10 days).
Then, the battery can be used or be placed for long period.
Lithium Battery
Features
1. This flash unit uses Li-ion polymer battery which has long runtime. The available charge-and-discharge times are 500.
2. It is reliably safe. The inner circuit is against overcharge, overdischarge, overcurrent, and short circuit.
3. Take only 4 hours to fully charge the battery by using the standard battery charger.
Cautions:
 Do not short circuit.
 Do not expose to rain or immerse into water. This battery is not water proof.
 Keep out of reach of children.
 No over 24 hours' continuous charging.
 Store in dry, cool, ventilated places.
 Do not put aside or into fire.
 Dead batteries should be diaposed according to local reglations.
 Long time not to use, please charge it to 60% and then placed.
 If the battery had ceased using for over 3 months, please make a full recharge.
Battery Level Indication
Make sure the battery pack is securely loaded in the flash. Check the battery level indication on the AV panel to see the
remaining battery level.
Power Management
ON/OFF Power Switch controls the on/off of the flash unit, turn off the power pack if the flash unit will not be used
for an extended period. The product design of power supply with automatic hibernation feature, When unattended
operation for a long time (approx. 30/60/90 minutes ), the flash will automatically standby.
Disabling Auto Power standby function is recommended when the flash is used off camera.
(C.Fn-F3, Page 39)
C.Fn
Modeling Lamp
With only the speedlite flash head have modeling lamp function, it will automatic turn off after 30 minutes.
Short press the modeling lamp button will control the modeling lamp turn on or off.
Wireless Flash Mode
AD200 can only be set as slave unit (receiver end). Long press the wireless selection button for 2 seconds to switch
the radio transmission function.
Wireless Mode
OFF
Radio Transmission
Flash Mode
M / Multi
TTL / M / Multi
Name of Parts
Attaching Bare bulb flash head
1 . Remove the reflector or other
accessories from the flash head.
2 . Match the red dot on the base of the flash tube with the red dot in the Tube
Socket (4). Push the flash tube in until it is securely seated into the socket.
- 31 - - 32 -