Sony WI-C300 Wireless In-Ear Headphones (Red) User Manual

Page 20

Conn

ec
tio
n

Op
er

ions

Using the Function Stored in the Memory of the RM-IP10

To set the speed of the camera moving to
a preset position between 9 and 16

To set the speed of the camera moving to a preset
position between 9 and 16, hold down the SHIFT button
and press the corresponding GROUP/POSITION
button.

Using the Function
Stored in the Memory of
the RM-IP10

The following function for panning/tilting operations
with the RM-IP10 is stored in the memory of this unit.

Setting a limit on the maximum
panning/tilting speed

You can limit the panning/tilting speed obtained when
you incline the joystick at the maximum angle.

Hold the PAN-TILT RESET button for more than a
second while pressing the SHIFT button.
All of the CAMERA buttons 1 to 7 flash.

Press the CAMERA button corresponding to the
speed you want to set, as shown in the table below.

For details on the setting of models which are not
mentioned above, refer to the VISCA value of each
model’s command list.

Only the CAMERA button you pressed flashes, and
the corresponding maximum panning/tilting speed
is set.

Note

If you use another RM-IP10 or you connect another
camera to this unit, set a limit on the maximum panning/
tilting speed again.

CAMERA
button

VISCA
value*

Maximum panning/tilting
speed
(Unit: degree/sec.)

BRC-Z700,
BRC-H900

BRC-Z330

0Ch (12)

3.5

4.4

0Eh (14)

6.4

6.7

10h (16)

11.6

12h (18)

18.3

18.6

14h (20)

29.2

16h (22)

43.4

18h (24)