GRAM KS 3315-93 X/1 - Manual (Page 73)

EN
7
3 Installation
B
Please remember that the
manufacturer shall not be held liable if
the information in the user guide is not
observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, and etc. have to
be fastened securely by adhesive tape
against any jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget…
That recycled material is an
indispensable source for the nature
and for our national resources.
If you would like to contribute to the
recycling of the packaging materials,
you can get further information from
the environmental bodies or local
authorities.
Before operating your
refrigerator
Before starting to use your
refrigerator check the following:
1. The interior of the refrigerator has to
be dry and it is possible for the air
to circulate freely at the back of the
appliance.
2. You can install the 2 spacers as
illustrated in the figure below. The
spacers will provide the required
distance between your refrigerator
and the wall in order to allow the air
circulation (The illustrated figure is
only an example and does not match
exactly with your product).
3. Clean the interior of the refrigerator as
recommended in the “Maintenance
and cleaning” section.
4. Plug the refrigerator into the outlet.
When the door is open the interior
light in the refrigerator compartment
will be switched on.
5. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
6. The front edges of the refrigerator
may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.