Epson DFX-9000 - Manual (Page 33)

Paper Handling 33
2
2
2
2
2
2
2
2
2
2
2
2
Adjusting the label position
Follow the steps below to adjust the label position:
Note:
See “Changing the settings in the SelecType mode” on page 101 to find
how to make settings in the SelecType mode and see “Changing the
settings in the default-setting mode” on page 103 to find how to make
settings in the default-setting mode.
1. Make sure that the printer is turned on.
2. Set the position for the settings listed below in the
default-setting mode.
3. Make the settings in the SelecType mode as shown below.
Label base pos.
Label top pos.
Label length
Label left pos.
Label width
Base sheet PG (Base sheet PG position number)
Label paper PG (Label paper PG position number)
Forms w/labels: On
Pge length front: paper length when using the front
tractor
Pge length rear: paper length when using the rear
tractor