Silvercrest TWINTALKER 4810 - Manual (Page 61)

Twintalker 4810 61
Twintalker 4810
EN
GL
ISH
6 Disposal of the device (environment)
At the end of the product lifecycle, you should not throw this product into the
normal household garbage but bring the product to a collection point for the
recycling of electrical and electronic equipments. The symbol on the product,
user guide and/or box indicate this.
Some of the product materials can be re-used if you bring them to a recycling
point. By re-using some parts or raw materials from used products you make an important
contribution to the protection of the environment. Please contact your local authorities in case
you need more information on the collection points in your area.
7 Using a PMR device
To communicate between PMR devices they need to be set all on the same channel and
CTCSS/DCS code (see chapter “13.7 CTCSS (Continious Tone Coded Squelch System) /
DCS (Digital Coded Squelch)”) and within receiving range (up to max. 8 km in open field).
Since these devices use free frequency bands (channels), all devices in operation share
these channels(total 8 channels). Therefore, privacy is not garanteed. Anybody with a PMR
set to your channel can overhear the conversation. If you want to communicate
(transmitting a voice signal) you need to press the PTT-button .
Once this button pressed, the device will go into transmit mode and you can speak into the
microphone. All other PMR devices in range , on the same channel and in standby mode (not
transmitting) will hear your message. You need to wait until the other party stops transmitting
before you can reply to the message. At the end of each transmission the unit will send a
beep if the Roger Beep is enable (see chapter “13.12 Roger Beep On/Off”). To reply, just
press the PTT-button
and speak into the microphone.
8 Included in the package
• 2 x Twintalker 4810
• 2 x Beltclip
• 1 x Duo Charger
• 1 x Power adapter
• 8 x AAA NiMh battery
• 2 x Earpiece with microphone and PTT - button
• User guide
• Card with service address and Hotline
11
11
If 2 or more users press the PTT- button at the same time the receiver
will receive only the stongest signal and the other signal(s) will be
supressed. Therefore you should only transmit a signal (press PTT-
button
) when the channel is free.
11
11
The range of radio waves is strongly affected by obstacles such as
buildings, concrete/metal structures, the unevenness of the landscape,
woodland, plants, … This implies that the range between two or more
PMR's may in some extreme cases be restricted to a maximum of a few
tens of meters. You will soon notice that PMR works best when there is
a minimum of obstacles between users.