Lanner LEC-3110 - Manual (Page 12)

10
Motherboard Information
Chapter 3
Embedded and Industrial Computing
Jumper Settings
SATA Connector (J10, J11): The system supports one
SATA drive with a transfer rate of 3 0 Gb/s This port
support both SATA and SATA DOM and detects between
them automatically
SATA Power Connector (J3): Connect the 4-pin SATA
power connector to this port
Keyboard and mouse interface Connectors(J7): It is
for connecting the PS/2 keyboard and mouse interface
cable
Clear CMOS jumper (JP2): It is for clearing the CMOS
memory and system setup parameters by erasing the data
stored in the CMOS RAM such as the system passwords
CompactFlash Primary/Slave Selection Jumper (JP1):
The system’s CompactFlash connects to LEC-3110’s
Primary IDE port in parallel with a reserved IDE connector
This jumper configures the CF socket to be the Master
(default) or Slave IDE device
CompactFlash Connector (CN2): It is for connecting a
Compact Flash card to be served as your system’s storage
The connector is a CF Type II slot which could fit both CF
Type I or CF Type II cards
Pin No. Function Pin No. Function
1 GND 26 CF_CD1#
2 CF_DD3 27 CF_DD11
3 CF_DD4 28 CF_DD12
4 CF_DD5 29 CF_DD13
5 CF_DD6 30 CF_DD14
6 CF_DD7 31 CF_DD15
7 CF_DCS0# 32 CF_DCS1#
8 A10(GND) 33 VS1#
9 OE#(GND) 34 CF_DIOR#
10 A9(GND) 35 CF_DIOW#
11 A8(GND) 36 WE#(VCC3)
12 A7(GND) 37 CF_IRQ#
13 VCC 38 VCC
14 A6(GND) 39 CSEL#(GND)
15 A5(GND) 40 VS2#
16 A4(GND) 41 CF_RESET#
17 A3(GND) 42 CF_IORDY
18 CF_A2 43 CF_DMARQ
19 CF_A1 44 CF_DDACK#
20 CF_A0 45 CF_ACT#
21 CF_DD0 46 CF_DIAG
22 CF_DD1 47 CF_DD8
23 CF_DD2 48 CF_DD9
24 WP(NC) 49 CF_DD10
25 CF_CD2# 50 GND
Pin No. Function
1 GND
2 TX+
3 TX-
4 GND
5 RX-
6 RX+
7 5V
Pin No. Function
1-2 Normal (Default)
2-3 Clear CMOS 3 2 1
Pin No. Function
1 VCV12 (12V)
2 GND
3 GND
4 VCC (5V)
Pin No. Function
1-2 Master (Default)
2-3 Slave
1
2
3
25 1
50 26
Pin No. Function Pin No. Function
1 VCC 2 MSCLK
3 MSDAT 6 KEY
5 KBDAT 6 KEY
7 GND 8 KBCLK
7 6 5 4 3 2 1
1 2 3 4
2 4 6 8
1 3 5 7