iSys i36 User Manual

Page 8

Text mode
Original mode

i36 ImageMaster User Guide

AC Power Cable - 220/230 Volt

CAUTION: Read the following procedure before connecting to a 220/230 volt
power source. The i36 ImageMaster power supply is not auto-switching.
Improper connection to a 220/230 volt power source will cause sever damage
to the PC/RIP and plotter.

CAUTION: The electronic components of the i36 ImageMaster can be
damaged by electrostatic discharge (ESD). To avoid ESD, maintain contact
with a ground source. A grounded wrist strap or similar device should be used.

WARNING: Electric shock warning.

NOTE: An optional 220/230 volt power cable is required for this procedure. Contact
iSys technical support for more information.

1. Remove the two screws in Figure 1 (7).
2. Locate the switches on the back of the power supply (see Figure 2).
3. Set the switch to 220/230 V.
4. Close hinged cover and replace screws.