iSys V36 - Manual (Page 19)

O P E R A T I O N
4.1 POWER SUPPLY PRECAUTIONS
Turn the plotter power switch OFF before doing any of the following:
1). Unplugging the plotter.
2). Cleaning the printhead.
3). Opening the plotter for maintenance or service.
4). Placing hands or tools near any internal parts.
WARNING: There are voltage hazards inherent in the printhead power supply
and AC input wiring. Take reasonable precautions to avoid electrical shock.
4.2 USING THE CONTROL PANEL
To turn the plotter on, press the main power switch at the back right side of
the plotter. The plotter will go through its boot-up sequence, then the display
will read: IDLE M1 with the ONLINE light on. When the ONLINE light is
on, the plotter is ready to receive data from the host. No changes to control
panel settings can be made in ONLINE mode.
The control panel is shown in Figure 4.1. It consists of an LCD display, three
condition lights and six buttons.
CAUTION: Take care not to discharge static into the plotter.
This may cause damage to the integrated circuits or to other
electronic components. Use an approved method of dissipation
or touching a grounded source.