Connecting usb devices, T 2 of, Figure 18 – H3C Technologies H3C MSR 800 User Manual
Page 23
16
3.
Insert LC connectors of the optical fibers to the Rx and Tx ports of the transceiver module.
4.
Connect the other ends of the optical fibers to corresponding ports of the transceiver module on
the peer device.
Make sure the Rx port of the transceiver module is connected to the Tx port of the peer
transceiver module.
5.
Power on the router and examine the port LED status. For more information, see "
."
Figure 18 Connecting optical fibers to a fiber port
NOTE:
•
Keep the connector on the optical fiber clean.
•
Insert the dust plug to the fiber port if no optical fiber is connected to the port.
Connecting USB devices
CAUTION:
To avoid data loss and hardware damages, do not unplug a USB device during data transmission.
IMPORTANT:
•
Use H3C-certified USB devices.
•
The USB port does not support hot-swapping of the USB modem from Sierra Wireless.
To connect a USB device to the USB port:
1.
Remove the cap of the USB device.
2.
Insert the USB device to the USB port.