ARM Electronics SDKBD2&3 - Manual (Page 6)

2. Rear Panel (Figure 2)
(Figure 2)
A. Power input connector: input DC12V power.
B. ID-Code switch: Used to set the protocol in use and the baud rate of communications.
C. Communication connector RS485: The controller is connected to adapter box by specific cable.
IV. Setting of the Keyboard
a) The protocol in use and the baud rate of communication of the keyboard are set by the
ID-CODE in Figure 2. DIP1-DIP4 are used to select type of the communication protocol as
per following table：
DIP status Normal Baud Rate
Protocols
DIP-1 DIP-2 DIP-3 DIP-4 DIP-5 DIP-6
COP-2 ON OFF OFF OFF OFF ON
Santachi OFF ON OFF OFF OFF ON
PELCO-D ON ON OFF OFF OFF OFF
PELCO-P/4800 ON OFF
PELCO-P/9600
OFF OFF ON OFF
OFF ON
PANASONIC ON OFF ON OFF OFF ON
Reserved OFF ON ON OFF OFF ON
HUNDA600 ON ON ON OFF OFF ON
LILIN OFF OFF OFF ON OFF ON
Reserved ON OFF OFF ON ON OFF
Reserved OFF ON OFF ON OFF ON
KALATEL ON ON OFF ON ON OFF
Reserved OFF OFF ON ON OFF ON
Reserved ON OFF ON ON OFF ON
COP-1 OFF ON ON ON OFF ON
Ultrak ON ON ON ON OFF ON
COP-03 OFF ON ON OFF OFF ON
COP-04 ON OFF ON ON OFF ON
b) DIP5 and DIP6 are used to select the baud rate, shown as following table (DIP7 and DIP8
are not used)：
Status of ID-CODE Baud
Rate
DIP1 DIP2 DIP3 DIP4 DIP5 DIP6 DIP7 DIP8
2400bps OFF OFF
4800bps ON OFF
9600bps OFF ON
19200bps ON ON
c) Some of the ID-CODE of the protocols are set as follows: