ARM Electronics SDKBD2&3 - Manual (Page 5)

FUNC
0
1 2 3
4 5 6
7 8 9
E nter C lear
WIDE TELE FAR NEAR
CAM/ID AUTO OPEN CLOSE
C urrentC am ID :001
SEQ PTZ/MULX LIVE TAPE
ON OFF F1 F2 F3
CALL PRESET SHOT
PTZ & Multiplexer
(Figure 1)
z Func（1 cam） ：Set special function of the system together with other buttons.
z Zoom（Full screen） ：Show picture of the camera in full screen. Press Zoom again to review a 2
Zoom of the selected camera.
z PIP（up arrow） ：Show picture of the camera in PIP mode (Picture-in-Picture).
z 2×2（down arrow） ：Show picture of the camera in 4-frame.
z 3×3（left arrow） ：Show picture of the camera in 9-frame.
z 4×4（right arrow） ：Show picture of the camera in 16-frame.
z Live：Show live picture of the camera at current mode.
z Tape：Playback pictures； Function + Tape: Playback video information of VCR.
z CAM: in multiplexer mode: Used with camera buttons to select cameras to display in the full,
PIP, 2×2,3×3,4×4 formats. in speed dome mode :Select address of the intelligent speed dome.
z F2: in multiplexer mode: Start automatic switching of cameras. This button is also used during
setup to turn on all motion detection targets. in speed dome mode :Auxiliary control buttons.
z CALL: To call the preset position.
z PRESET ： To set the preset position.
z SHOT ： To set up or call cruising track.
z AUTO：To control auto-horizontal rotation for pan/tilt .
z WIDE：To a wide angle.
z TELE：To turn to a telescopic range.
z FAR：To make focus far manually.
z NEAR：To make focus near manually.
z OPEN：To open iris.
z CLOSE：To close iris.
z ON：Switch on the setting of function.
z OFF：Switch off the setting of function.
z F1：Auxiliary control buttons.
z F3：Switching control between intelligent speed dome and multiplexer.
z [0]-[9]：Number key
z [Clear]：To clear inputted data
z [Enter]：To confirm