Alinco DR-SR8 - Manual (Page 81)

79
Chapter 6 Parameter Setting Mode (Set mode)
Menu 14. Electronic Keyer Reverse Setting
When Electronic Keyer setting is ON (Refer to menu 12), you can change the dots and the dash
keying positions (left and right strokes).
Default is [PADDL-N] and operates in normal
1.
position.
2.
Turn the main dial clockwise, the display
changes into the [PADDL-R] and reverses the
position.
counterclockwise clockwise
PADDL-N PADDL-R
Menu 15. Sidetone (CW Offset) Setting
The sidetone will change according to the CW offset you select.
1.
The [ST-800] appears on the display.
(Default)
By rotating the main dial, the display changes
2.
as shown and the sidetone is changed.
ST-400 ST-1000 ST-450 ... ST-800 ... ST-950
(Hz)
Menu 16. Break-in Delay Time for CW operation
You can select from AUTO BREAK-IN, SEMI BREAK-IN (selectable in 7 steps), and FULL
BREAK-IN.
1.
The current Break-in setting appears on the
display.
You can change the break-in types as below
2.
by rotating the main dial.
BKIN-FL BKIN-7 BKIN-1 BKIN-2 ... BKIN-6 BLIN-AT