Watson-Marlow 620U - Manual (Page 34)

Watson-Marlow 620UN, 620U, 620SN, 620S User Manual 34
16.1 Trim
UN
When the pump is under remote control, it tracks an analogue signal from the user’s
remote control system to the i/p terminal of the Analogue 1 connectors at the rear
of the pump within the ranges 4-20mA, 0-10V or 1-5V. The Trim setup sequence
allows the user to customise the process-signal-to-pump-speed calibration. The
sequence may be entered directly from the Setup menu or from the Analogue setup
menu.
U
When the pump is under remote control, it tracks an analogue signal from the user’s
remote control system to pin 4 of the lower D-connector at the rear of the pump
within the ranges 4-20mA, 0-10V or 1-5V. The Trim setup sequence allows the user
to customise the process-signal-to-pump-speed calibration. The sequence may be
entered directly from the Setup menu or from the Analogue setup menu.